 |
|
|
| |
AUTOTUBE-100
A stand-alone, high-speed, professional and low cost automatic handler |
|
 Download
PDF data sheet
Specifications
Ordering Information
|
Characteristics: |
- Connects to the high speed programmer (PRO-201) to become a high speed automatic programmer.
- Various IC packages such as DIP, PLCC, SOP, etc. can be programmed using hardware modifications for DIP300mil, DIP600mil, PLCC32, PLCC44, SOP150mil and SOP300mil.
- Accepts testing pins which can be used million of times. The testing pins can be replaced in 15 minutes.
- Loading blank chips is quick and easy as is the removal of successfully programmed chips. It takes not more than 15 seconds to load and remove the chips.
- Automatically separates devices which have been successfully programmed from those unsuccessfully programmed.
- The IC jam rate is less than 1/1000 and it takes less than 30 seconds to remove a jammed chip.
- Automatically data save -- After the Autotube-100 is turned off, all programming data will be automatically saved. The next time the data will still be available for use when the machine is switched on.
- Superior design prevents operator from committing unintentional errors.
- Modular design allows easy maintenance and repair.
|
| |
Specifications |
|
|
| |
Electronic specifications
- Autotube-100 control panel: Display the programming status and allows your to set desired conditions such as the number of chips to be programmed and the number of chips loaded into a tube.
- Built-in power supply ( 90 - 245VAC and 80W )
Mechanical specifications
- Cylinder operation pressure: 5 bar ( 0.5 mpa )
- Air consumption: 0.6 liter/min
- Test pins: T-O Bare Board Probes
- Hose diameter: a 6.0 mm diameter ( D6.0 ) hose
- Hose input aperture: a 6.0 mm diameter
|
|
| |
Ordering Information: |
|
|
| |
Product and sales on request
|
|
|
|
|
